I'm running all mine with this update (SP5a) and I'm not having any problems. One thing to check is to make sure the amount of cells is still set to 2 after updates. Good luck and Have a Very Merry Christmas my friend.@Wingsfan0310 Steve I updated to SP5 and the battery meter shows 0%. Tried hard boot, soft boot, remove battery nothing. Went back to SP3 no meter did the boot stuff again, no help. Went back to SP5 no meter, boot stuff again no help. Batteries reading 7.3 volts (VT133) All the boot stuff was from the Evolv forum. Any ideas?
PS One other thing to try is remove the cells for a minute or so and see if that resets the battery meter.
[RECOMMENDED]
*** EScribe 1.2 SP5a ***
https://downloads.evolvapor.com/SetupES_1_2_SP5a_ServicePack.exe (11MB service pack)
https://download-mirror.evolvapor.com/SetupES_1_2_SP5a_ServicePack.exe (slower, alternate download link)
This service pack is mostly bug fixes.
On the device side:
- DNA 200 and DNA 250 no longer lose the battery meter on startup sometimes.
- Calibration values have been improved slightly for newer DNA 200s and DNA 250s. (More accurate USB Voltage, mainly.)
- Temperature Protected and other messages now show the correct number of flashes again.
- Some VaporShark DNA 200s would reset charging when above 0.8A with 1.2 SP3 and 1.2 SP4. They now charge at full speed.
On the EScribe side:
- Device Monitor no longer shows Battery Cell 3 on 2-cell devices (except in debug mode).
- Get Information shows test information in an easier-to-read form.
- Production Utility's Battery Test is now more thorough. It also shows a progress bar.
- Production Utility's Fire Test completes more quickly now. It also shows a progress bar.
- This resolves some more scaling issues in Large Fonts mode and some crash bugs.
- Minor bug and compatibility fixes.
[SP5a fixes a few minor EScribe bugs in SP5.]