After trying the SXK clones of the Exocet, the Insider, the VapeShell, Aspire Triton RTA (in the A-tank), an Aspire Triton 0.5 Ohm Clapton coil (in the A-Tank), an authentic Bastard Coil (with a vertical 0.2 ohm SS notch coil), and the Kanger-style RBA head...
I think my favorite of all of them right now is the Kanger-style RBA head. Right now the build I have in it is 6 spaced wraps of 30g SS316L on 3mm ID, which comes out to ~1.2 Ohms, and in TC mode with a TCR of 0.00111, I am running it at 13w and 420F. I have it wicked with a minimal amount of cotton, which I thought would be gurgling or leaking, but it's ok, and even less than what I used previously in this atty, and less than what I used in the Insider, all with my DIY 90VG juice.
This build is giving the most flavor so far, with a restricted DTL and no J-wraps condensation plug nor one of Troy's
@troydestroy DryPlugs at the moment, with no condensation seen yet after 3 refills of the boro. the vape and clouds are both very satisfying, with a surprising amount of nice moist heat at the drip tip.
Below is a screen cap of the Steam Engine settings:
I am going to see how this performs for a while and if I decide to keep using this setup, may sell off the duplicates I have of the SXK Exocet, SXK Insider and SXK VapeShell, and I will post here first to give you guys first dibs.
Also, I did not forget about measuring the displacement and capacity of the various attys that I have and reporting that info, but life has gotten in the way. I hope to do that and share here either tomorrow or Sunday. Sorry for the delay to those who may be waiting on this info...