Nightowl001
Member For 4 Years
I have been reading for the last two days (actually way more, off and on for the last month before I finally built my first set of coils). Either I have read too much and somehow managed to mis-interpret the information and make myself more confused, or I just simply do not understand temp control.
I am using the Smok Alien220, Limitless RDTA, dual coil, SS 316 28 ga wire, 8 wraps spaced, 3 mm ID (0.410 ohms), and the settings on the MOD are: temp mode (have tried everything from 400℉ to 500℉) , set to SS, I have tried just about every strength setting from 35 watts to 110 watts, TC-SS is set @0.00092, I have tried raising and lowering this between 0.00088 & 0.00105 (0.00105 was where it was set from the factory). I have also opened and closed the air flow control.
I chain vape!
This issue I am having is the MOD is constantly going into temp protection. Sometimes I'll get 5 good hits, sometimes it goes into temp protection every hit. It appears to continue to fire even when the MOD displays "temp protection". I'm not sure if what I have learned and put to use is my mis-interpretation of temp mode or if this is normal. I just don't want to damage my MOD....or my face!
I have read a lot on a lot of different searches. I also found a page that claimed to completely explain temp control on the Smok Alien...and they really didn't.
I will say this, so far the flavor IS much better and the cotton is not brown on day two of this setup. Normally, my cotton is already brown using kanthal after a couple of hours of use.
Sorry for the long post, but I wanted to try and put everything in that I can think of. Thanks all!
Sent from my HTC6535LVW using Tapatalk
I am using the Smok Alien220, Limitless RDTA, dual coil, SS 316 28 ga wire, 8 wraps spaced, 3 mm ID (0.410 ohms), and the settings on the MOD are: temp mode (have tried everything from 400℉ to 500℉) , set to SS, I have tried just about every strength setting from 35 watts to 110 watts, TC-SS is set @0.00092, I have tried raising and lowering this between 0.00088 & 0.00105 (0.00105 was where it was set from the factory). I have also opened and closed the air flow control.
I chain vape!
This issue I am having is the MOD is constantly going into temp protection. Sometimes I'll get 5 good hits, sometimes it goes into temp protection every hit. It appears to continue to fire even when the MOD displays "temp protection". I'm not sure if what I have learned and put to use is my mis-interpretation of temp mode or if this is normal. I just don't want to damage my MOD....or my face!
I have read a lot on a lot of different searches. I also found a page that claimed to completely explain temp control on the Smok Alien...and they really didn't.
I will say this, so far the flavor IS much better and the cotton is not brown on day two of this setup. Normally, my cotton is already brown using kanthal after a couple of hours of use.
Sorry for the long post, but I wanted to try and put everything in that I can think of. Thanks all!
Sent from my HTC6535LVW using Tapatalk