@fidola13 to my understanding Yihi made this particular chipset for Steam Crave.I wonder why they used that particular Yihi chip in this mod especially when there are more updated or latest Yihi chips available?
@fidola13 to my understanding Yihi made this particular chipset for Steam Crave.I wonder why they used that particular Yihi chip in this mod especially when there are more updated or latest Yihi chips available?
@fidola13 to my understanding Yihi made this particular chipset for Steam Crave.
Good old YiHi rattle snake action going on... It's normal and why I don't do TC on YiHi products, especially with YiHi boards that are not mainstream and specifically made for other manufacturers. SC should have gone with Evolv IMHO.I also posted about this over in the Steam Crave Mesh Deck thread:
Is anyone using the Hadron in temp control with SS mesh? I'm finding that when the mesh gets to temp, the mod starts rapid pulsing to maintain temperature. My DNA mods don't do this, and the Hadron doesn't produce a noticeable pulsing when using wire coils.
Sent from my iPhone using Tapatalk
Agreed 100%. Going to keep the Hadron in wattage mode. For TC I'm spoiled by DNA mods and even my Hohm Slice with the FSK chip. I wish Hohm Tech would either license that tech or sell the boards to mod makers, that thing does fantastic TC.Good old YiHi rattle snake action going on... It's normal and why I don't do TC on YiHi products, especially with YiHi boards that are not mainstream and specifically made for other manufacturers. SC should have gone with Evolv IMHO.
I have 2 Wreckers and a Slice myself, they don't get much use these days though.Agreed 100%. Going to keep the Hadron in wattage mode. For TC I'm spoiled by DNA mods and even my Hohm Slice with the FSK chip. I wish Hohm Tech would either license that tech or sell the boards to mod makers, that thing does fantastic TC.
Did you look in the manual? Look there 1st.Is it possible to lock the resistance on the Hadron? I'm trying my SS316L wire in power mode, I'm noticing the resistance is being read again after firing and as SS wire does, the resistance increases as the wire is heated.
Did you look in the manual? Look there 1st.
@VinnySem I found how to lock the resistance with ss316L.I did, there are instructions on locking the mod altogether, but not the resistance.
But good news, I've figured out how to mitigate the pulsing... it seems to be most noticeable when the wicking is packed a little too tight in the coil. I put a new build in my tank and it's barely noticeable now.
Sent from my iPhone using Tapatalk
@VinnySem I found how to lock the resistance with ss316L.
Press middle button, as soon as the ohm value is visible on the screen, press the fire button to lock in the resistance.
You’re welcome!Thank you for that!!
Sent from my iPhone using Tapatalk
It’s coming along but the factories are closed for about 2 weeks for Chinese New Year. I’ll let everyone know it’s status after Chinese New Year is done.Any news on the hardon squonk add on?
You’re welcome!
Yep then you would have to wait again until the coil cools.Ok I found an issue with that method. If you adjust the watts, you have to hit the fire button to set the new power level, which then again reads the coil resistance. If you've just vaped on it, the coil is warm and resistance will be higher.
Sent from my iPhone using Tapatalk