Ni200 24 AWG 4.0mm diameter 6 wraps (5 excluding half wrap [or is it 4 ?])
anywho, It's clocking in at .05 ohms on my ohm meter. It was .08 ohms but after moving the coil around a bit more with the jig it dropped to .05 ohms? Nothing is touching
after untightening and retightening the screws its still at .05 ohms now. I found this odd. The legs are bent inside where the screws are however, is this okay/normal for installing coils?
anywho, It's clocking in at .05 ohms on my ohm meter. It was .08 ohms but after moving the coil around a bit more with the jig it dropped to .05 ohms? Nothing is touching
after untightening and retightening the screws its still at .05 ohms now. I found this odd. The legs are bent inside where the screws are however, is this okay/normal for installing coils?