Margie
Member For 4 Years
Not sure if this is right place to post but wanted to know how others deal with using single coils on drippers that are usually meant for multiple coils. I use my RSST's & R91's for out & about but prefer my drippers for home and for testing my DIY recipes. I have an assortment of drippers and build higher ohm single coils. My Igo- W's have been getting the most use and my husband has drilled out the toppers to my favorite draw. However I now find that I like the IGO PMMA top covers better, but they have two large air holes which I have fixed by covering one with Scotch tape (works great for now).
I have a piece of pipe cleaner crammed in on one side of the air hole on my IGO- W7 and super glue covering one air hole of my Helios. I'm sure other people have the same problem and was hoping that someone has come up with a better solution for covering holes that have no air flow control. Have even tried using the plug from my RSST fill hole and using tiny screws. Not looking for a permanent fix because I sometimes do dual coils. Any suggestions?
I have a piece of pipe cleaner crammed in on one side of the air hole on my IGO- W7 and super glue covering one air hole of my Helios. I'm sure other people have the same problem and was hoping that someone has come up with a better solution for covering holes that have no air flow control. Have even tried using the plug from my RSST fill hole and using tiny screws. Not looking for a permanent fix because I sometimes do dual coils. Any suggestions?