Well, I am distraught and discouraged tonight, particularly about squonking. Someone here was kind and generous enough to PIF me a squonk mod and a tiny squonk atty... and Cromwell PIFed some stuff too, which is primarily for my son, but there was also an RDA which has a squonk pin. I'm distraught and discouraged because the squonk mod is a SteamCrave, which apparently can only be adjusted in 1w increments -- so I can vape at 9w, which is a bit mild, or 10w, which is a bit hot, but there is no way to adjust between them. I did setup the RDA that Cromwell sent, because I thought if I closed off ALL the airholes, it might be a tolerable MtL vape, but it's not, it's so loose and open that there's a natural reflex to DtL inhale... which leaves me coughing and groping around for my rescue inhaler. Just got over that.
I haven't yet tried the tiny squonk atty that the squonk PIF'er sent (I won't blab if you don't want me to, I'm not sure of the etiquette for such things, but you know who you are!), because I'm not sure that airflow can be tightened very much either -- I think he said it's an Origen Little, and so it has an airhole on each side, and the airholes are so close together that if you try to have just the edge of airhole showing, it shows the next one in line too. I probably will set that one up, just to see if I can make it work... but with only being able to vape at 9w or 10w... well, neither is my preference (I can tolerate 9.5w if I'm using one of my CF4s, but I really prefer 9.4w or 9.6w). If I could find an atty tight enough, I could use one of those super-long driptips like ePipes use, so that the 10w would be bearable. But finding an RDA which is both a) squonkable, and b) tight enough draw... I'm really not sure that's possible at all.
Andria