All the time after I put a build in the coils get kinda wobbly and the numbers get crazy like 1.45 or more.. how do I fix that plzz?
Yep. Heating and cooling tend to loosen things up.Grub screws are not tight enough after dry firing - the most likely culprit
YepGrub screws are not tight enough after dry firing - the most likely culprit
Grub screws are not tight enough after dry firing - the most likely culprit
Grub screws are not tight enough after dry firing - the most likely culprit
Assuming your using Kanthal..... Once heated it becomes softer so the grub screws tend to hold it looser, thats where your wobbly coils are coming from. with a loose connection the resistance (Ohms) will increase, hence your numbers going up. Higher numbers arent the dangerous part, LOW numbers are. with lower builds (.05 .1 .007 and such) will draw a LOT of amps from your batteries and that is when you get into trouble. Regulated mods are a lot safer, but I still wouldn't just run any build on crap batteries even in regulated mods.
What Is the build? Atty and mod.
Could be any loose or bad connection in the circuit from the post pole of the battery to the negative......
Sent from my SCH-I605 using Tapatalk
I wouldn't use those batteties..... they are not even of the correct voltage..
Costing allot and having fancy wrapper doesn't equal a good battery.
Sent from my SCH-I605 using Tapatalk
I agree, I must type slower.I wouldn't use those batteties..... they are not even of the correct voltage..
Costing allot and having fancy wrapper doesn't equal a good battery.
I realize that but I bought them from Pegasus Academy specifically Vape related. Dude has good vids on utube. Not real expensive.. but maybe not necessarily for this mod wasn't sure that's why I asked. What u mean correct voltage, they're too low?
Yeah being on youtube doesn't make you a trustable authority. . Either...I realize that but I bought them from Pegasus Academy specifically Vape related. Dude has good vids on utube. Not real expensive.. but maybe not necessarily for this mod wasn't sure that's why I asked. What u mean correct voltage, they're too low?
No... there is no protection from you running a sub par battery. The mod can still pull more amps from a battery than a battery might have to offer.... just because the mod will shut off if you pull more than say the 25 amps it's rated for..... doesn't mean it cant pull 25 amps from a 5 amp battery......it will probably error before smoking.. but i don't want to test the safety protections.If they're not correct the built in defense system in a regulated mod wouldn't allow them right? So they must be ok..
Your likely slightly deforming the coil when your removing the old wick. Use scissors to cut one of the tails then proceed to remove the old wick.All the time after I put a build in the coils get kinda wobbly and the numbers get crazy like 1.45 or more.. how do I fix that plzz?