Hello,
I have recently purchased a RX300 used, and I have noticed that even before purchasing it, I tested it with my Atomiser (RTA Deepfire) 2x 0.5 Ohm clapton coils at 0.25Ohms total.
I tested the atomiser on a iStick TC40W and the coil readings were 0.25Ohms, I even tested it on a Joytech vtwo mini and the coil reading was 0.26 Ohm.
On the RX300 the coil readings are 0.38, 0.44, 0.48, 0.51, all up to 1.9ohms.
It is all over the place.
When i press the fire button, the resistance drops to where it SHOULD be, 0.25-0.26 ohms, but it shoots back up after use.
Is there any way to fix this?
What i tested:
cleaned the 510 pin, the thread, updated the firmware, switched to arcticfox firmware, and still the same.
Is there any way that i can set the coil resistance MANUALLY? Any firmware?
I have recently purchased a RX300 used, and I have noticed that even before purchasing it, I tested it with my Atomiser (RTA Deepfire) 2x 0.5 Ohm clapton coils at 0.25Ohms total.
I tested the atomiser on a iStick TC40W and the coil readings were 0.25Ohms, I even tested it on a Joytech vtwo mini and the coil reading was 0.26 Ohm.
On the RX300 the coil readings are 0.38, 0.44, 0.48, 0.51, all up to 1.9ohms.
It is all over the place.
When i press the fire button, the resistance drops to where it SHOULD be, 0.25-0.26 ohms, but it shoots back up after use.
Is there any way to fix this?
What i tested:
cleaned the 510 pin, the thread, updated the firmware, switched to arcticfox firmware, and still the same.
Is there any way that i can set the coil resistance MANUALLY? Any firmware?