So I'm new to building coils and this is my first time with an RTA. I'm using the Vaporesso Revenger kit with a Zeus RTA (single coil). So I went ahead and built a parallel coil (I was recommended to do so by the guy from the vape shop where I bought it) and wicked it up before testing for hot spots. That gave close to no vapor and an instant dry hit so I started over following a YouTube tutorial and realized I forgot to check for hot spots and so on my second attempt I did and it wasn't glowing at all. The build came to 0.25Ohm (which dropped down to 0.21Ohm when firing). Not quite sure what I did wrong here.
Thanks for the help in advance,
SavantCS
EDIT: Perhaps some more info would help: I'm using Kanthal A1 24 gauge wire for the parallel coil and wound it around a 3mm bit 5 times.
Thanks for the help in advance,
SavantCS
EDIT: Perhaps some more info would help: I'm using Kanthal A1 24 gauge wire for the parallel coil and wound it around a 3mm bit 5 times.
Last edited: