help please

[cordar]

so i ordered one of these
http://www.fasttech.com/products/0/...ble-wattage-kick-module-for-mechanical-mod-pv

my question..... is this a clone???? how low of a atty can i build with this? its says 1.5 to 3 but i thought it could go to .5? it goes to 12 watts. i thought the kick 1 went to 10 watts. If you have one, have you built below 1.5? thanks.

 

[SilverZero]

It is definitely a clone. Genuine Evolv products are not sold by FastTech.

Perhaps someone who owns one can confirm the minimum resistance, but if the site says 1.5 I wouldn't go below that.

 

[UncleRJ]

Don't mess with the spec's.

They will bite you on the ass every time!

 

[cordar]

i here ya......so with that said.... 12 watts at 1.5 ohms is not that good of a vape. prolly round 4 volts. so why use a kick???? i understand that its a consistent vape while using a mech, but not that great of a vape either

 

[Freeloader]

12 watts at 1.5 would be 4.24 volts. At .5 and 12 watts you would get 2.45 volts. Kicks weren't designed for sub-ohms as your wattage is regulated. A fresh battery, let's say 4 volts, with a .5 ohm coil will produce 32 watts.