I put a plain dual coil in mine (SS316L) with a 3 mm ID, works just fine.Just got a griffin today and was wondering what builds everyone is using in theirs. And also I heard wicking can be tricky so if anyone can give me any recommendations I would really appreciate it.
Thanks
Mreeveshp
Sent from my VS990 using Tapatalk
I used twisted coils but changed to Claptons and its delicious. What I do when wicking is I put my cotton on and take the cap press down to make marks on the cotton then cut the cotton slightly below the mark then gently put in between the juice well ring. Put some juice on the cotton and see if I have to make any more cuts at that point put the tank on close the juice wells put my juice in open the juice wells then my air flow and finally put the cap on if u did it right, after a min u should see about a mm or two already soaked into ur cotton.I finally got a griffin today and was wondering what builds everyone is using on it and also what wicking technique cause I heard it's tricky to get it right on the griffin so any help will be much appreciated.
Thanks
Mreeveshp
Sent from my VS990 using Tapatalk
I usually use 28g SS 316L for dual coils, and 26g for single.Neunerball I ended up doing a .25 ohm dual kanthal and it's working great but I might do a SS later
How do you guys do quotes and the ohm symbol
Sent from my VS990 using Tapatalk
I finally got a griffin today and was wondering what builds everyone is using on it and also what wicking technique cause I heard it's tricky to get it right on the griffin so any help will be much appreciated.
Thanks
Mreeveshp
Sent from my VS990 using Tapatalk