I got one from 101 as well, it gave up the ghost and kept showing check atomizer. Being the nerd I am, I tore it open and didn't even think to call about a warranty. Replace the 510 and wiring, and still no dice. so I tore it all out for an SX350. If you figure out a good way to modify the screen to fit an SX 350 let me know. From what I can tell with my SX350 chip pressed in to place (yeah it fits in the space where the chna30 chip was glued in, but tightly) is that the window is already too tall. you could easily remedy this by using a piece of plexi and putting a tint film on so that it could fill in the gaps around, or use some sort of bezel. The second area i see an issue is that the chip is a little longer than the chna30, and the clearance on the chip fitting in is tight, so you may run in to issues with the switches. you will definitley have to remove most of the glue from clopor. you could always grind some center section away, but id bet it would be too much trouble and affect where the screen rested. When disassembling mine completely, the glue was a bitch to get out, I had to run my heat gun to get it liquid enough to remove parts, but it made a mess. . . rubbing alcohol and acetone helped to get it off the interior. Another consideration, which im hoping may pan out, would be to get your hands on an SX330 chip,
http://www.yihiecigar.com/products_info/YiHiEcigar-SX330-V3-100W-New-Vapor-Chip-270814.html and put that in place, you would obviously have to remove the switches and wire up remote ones, but i think this may be a better soultion for the CANA case, really just depends on what the screen size is.