Hey i am very new to building I got a bellus rta I know it's not best but it was dirt cheap so I thought I would play around with it and get used to building coils etc..
Anyway I have successfully built coils for and changed it this morning again my question is before wicking ohm reader and my mod reads it 0.25 which I wanted to get but after wicking it reads 0.32 ohm reader and mod reads same. I mean don't have problem with that ohm but why can't I get it at 0.25?
I used coil calculator website and the app to get 0.25 wrap counted and ID etc..
I have kanthal A1 24awg I used drill bit that 2.38mm 6 wraps it should come up at 0.25 but final ohm is 0.32
What am I missing here?
Thanks
Anyway I have successfully built coils for and changed it this morning again my question is before wicking ohm reader and my mod reads it 0.25 which I wanted to get but after wicking it reads 0.32 ohm reader and mod reads same. I mean don't have problem with that ohm but why can't I get it at 0.25?
I used coil calculator website and the app to get 0.25 wrap counted and ID etc..
I have kanthal A1 24awg I used drill bit that 2.38mm 6 wraps it should come up at 0.25 but final ohm is 0.32
What am I missing here?
Thanks