Become a Patron!
Any interest in a step by step guide to OKR/Raptor mods?
- Thread starter brian2778
- Start date
So here's my raptor 1590B box with shaved top and bottom to stand straight. Worked great and I like the way it looks. Not completely done yet, waiting for replacement voltmeter(cat ate mine). I do have it completely wired with a temporary meter and have tested it and it works amazingly. Dual 26650s and the full no idle drain circuit with selectable voltmeter(input or output).
It's pretty ugly but here you go. As I said it's not completely finished, I still need to install the right size meter then I was going to use epoxy to insulate and secure everything.
I used stripboard to make my battery holder and was able to use it to make my connections to the caps, pulldown resistor and zener diode.
For the jumper side I just soldered tabs onto stripboard and built up the traces between them, then just epoxied it in place. Works great and low profile.
Temporary .36" meter until my replacement .28" one gets here.
I used stripboard to make my battery holder and was able to use it to make my connections to the caps, pulldown resistor and zener diode.
For the jumper side I just soldered tabs onto stripboard and built up the traces between them, then just epoxied it in place. Works great and low profile.
Temporary .36" meter until my replacement .28" one gets here.
Wow That is built like a tank nice job... How much and timeline for delivery!If anyone wants the info, let me know and I'll start an imgur album to give you a little help.
If you don't want to build it yourself there are usually boxes for sale on eBay.
