you need higher resistance
both because that build is not safe on a vtc6 with cdr of 15amps, and because it will provide the cooler vape that you want
15 ampBut it says that 15A and 30A what should i flow ?
So what about using 0.17 coils??
Sent from my iPhone using Tapatalk
I didn't know how to say it without sounding like I was bashing him. But more knowledge is definitely needed than it being a quick plug and play vape. This is in the territory of a bomb. Be safe and read read read
The VTC6A IS a 15 amp max continuous discharge cell.
Where did you read the 30 amps?
btw I vape single cell mechs with a 20 A battery and a .25 - .35 coil build. Warm but not hot vape.
Enjoy your vape but please be safe.
People that use mechs have to go to low ohms to get a big vape becuase they have a maximum of about 3.6 volts or so coming out of the battery under a heavy load.Thank you very much. I will change my coil to 0.28. Last question. People use mech mod to go for low ohms but know we are using high ohms !!!
Im really thankful for you help
Sent from my iPhone using Tapatalk
People that use mechs have to go to low ohms to get a big vape becuase they have a maximum of about 3.6 volts or so coming out of the battery under a heavy load.
With regulated mods you can adjust up the voltage and use higher ohms coils and get the same or better vape.
the regulated mod will adjust the voltage up or down. It actually boosts or drops the voltage coming from the battery/s.
They also provide safeties like low voltage cutoff for the battery.
Discharging a LI battery too low can be very dangerous.
And you are very welcome.
If you are going to use mechs I strongly recommend you to watch some of Mooch's videos onYoutube.
https://www.youtube.com/channel/UCePHh3NMvu3rW2LFJeOWo-Q
Ohh very safe but likely fairly low vapor production and cool.Ok what if i use 0.5 ohms it will use only 7.4A so is it safe ??
And why just go for voltage mod instead if mech (it will give you the same performance and safer) ??
Sent from my iPhone using Tapatalk
Ohh very safe but likely fairly low vapor production and cool.
That is another issue with a mech. to get the right temp vape you have to fiddle with different style and ohm coils with a regulated you just adjust the watts up or down.
I would say .25 - .4 max. Anything above .25 should be safe with a VTC6.
But just an educated and somewhat experienced guess.
Depends on the atty, coil ohms and mass and some batteries hit harder than others in a mech. in other words less voltage drop under load.
Once you get the right coil to suit you, you will notice your vape temp and quality dropping. It will get pretty weak about 3 volts or so non loaded voltage in the battery. The danger level for over discharge is around 2.5 volts and lower.So the safest for me is 0.25 and above?
Im wandering how to avoid the low discharge thingy?
Sent from my iPhone using Tapatalk
Once you get the right coil to suit you, you will notice your vape temp and quality dropping. It will get pretty weak about 3 volts or so non loaded voltage in the battery. The danger level for over discharge is around 2.5 volts and lower.
If your charger displays voltage use this as a guide combined with how the vape is doing.
It does not hurt a battery at all to charge it before it goes all the way to 3 volts or lower.
As a matter of fact it will lengthen it's life a bit.