Become a Patron!

Ohms going down?

SagsMcGee

Member For 1 Year
Howdy! I'm using a deruga RDA on my smok Procolor and I've noticed that my ohms are going down? I'm not sure what's causing this but everywhere I look it just says it's supposed to go up a little, the only thing I can think of is I switched from a really sugary juice to a sugar free juice and the gunk is burning off but other than that I have no clue.

Anyone know why this is happening and if it's a bad thing or not?

Thanks

Sent from my SM-G935V using Tapatalk
 

lucifah

Shinyitis Victim
VU Donator
Bronze Contributor
Member For 3 Years
Going down when exactly? By how much?

What's the material?
Loose grub screws?

If, for example, you dry burned a stainless steel coil and then put it on your mod, it would still be cooling down after reading resistance initially, resulting in a drop in resistance.

If the screws are loose, it could have been read higher initially and then lower as the material extends ever so slightly due to heat and potentially makes better contact.

I don't know the mod, but these things have happened to me a while back. Not very likely but possible.
 

SagsMcGee

Member For 1 Year
Thank you so much for your reply! But I think it was just my mod being stupid, my coil went from .115 ohms to .105 and I was kinda worried something was messed up so I went out and got an actual ohm reader, put my RDA on and it said .12. I was so confused and I put it on my mod and then my mod said the same thing. Confusing as hell but just like everyone said it should be doing it was actually going up. Sorry for wasting your time
Going down when exactly? By how much?

What's the material?
Loose grub screws?

If, for example, you dry burned a stainless steel coil and then put it on your mod, it would still be cooling down after reading resistance initially, resulting in a drop in resistance.

If the screws are loose, it could have been read higher initially and then lower as the material extends ever so slightly due to heat and potentially makes better contact.

I don't know the mod, but these things have happened to me a while back. Not very likely but possible.

Sent from my SM-G935V using Tapatalk
 

lucifah

Shinyitis Victim
VU Donator
Bronze Contributor
Member For 3 Years
Thank you so much for your reply! But I think it was just my mod being stupid, my coil went from .115 ohms to .105 and I was kinda worried something was messed up so I went out and got an actual ohm reader, put my RDA on and it said .12. I was so confused and I put it on my mod and then my mod said the same thing. Confusing as hell but just like everyone said it should be doing it was actually going up. Sorry for wasting your time

Sent from my SM-G935V using Tapatalk

No worries! A bit of deviation between different devices appears to be normal.
 

VU Sponsors

Top