I was thinking if all factors were the same2x28/38 will be thicker(taller), 4x30/40 will be wider
If the wires are all the same alloy, the time they take to heat up depends entirely on the wattage you set on your Drag Mini plus how much metal is in the final build - how many wraps and inner diameter - the mass of the metal overall
You can use wire wizard on steam-engine.org to see coil mass
These r both n80really worried about those NI90 coils arent you?
These r both n80 coilsreally worried about those NI90 coils arent you?
I wud run both on 100 watts.28×2+38. But the difference is extremely very small, and, because 30×4+40 has more total surface area, this is only hypothetically speaking so, in practice, the opposite will be true because having more total surface area also means it generally deserves extra wattage.
Personally, I, would always run every coil build at whatever the wattage will be needed to make it vape just how I like it best. On a regulated mod it means starting at a reasonably moderate wattage and then gradually bumping it till it feels right, taking it back down a notch if it is a little too high, and, it actually even also depends on what flavor the juice is, among a few other factors.I wud run both on 100 watts.