just bought a Rx200s with tfv8 baby beast tank , was woundering at wattage should i be using it at ? And what does the volt mean on the sreen is there certain level I should have the volt at ? And wattage ? Thanks !
Which of the coils do you have in the tank? That will determine a good starting point.
I've usually started about 5w lower than what the recommended coil rating shows, and then work my way up.
Typically, I end up sitting somewhere in the middle of the recommended range.
V8 Baby Q2 Coil Head -- I'll run at about 55w
V8 Baby X4 Coil Head -- I'll run at about 50w
- 40 to 80W Range
- 55 to 65W Recommended Range
[/QUOTE
- 30 to 70W
- 45 to 60W Recommended Range
V8 baby coil I have is .15 and .2 , when I first got it a few days ago , it was working greatly then and I switched the coils and and wasted producing the same cloud like when I first used it
V8 baby coil I have is .15 and .2 , when I first got it a few days ago , it was working greatly then and I switched the coils and and wasted producing the same cloud like when I first used it
Make sure that you have the coils good and primed, then do some good air pulls (without firing them) on the tank with juice in it. This will get the tank to draw the air into a vacuum so that the juice doesn't leak out.
The .15ohm
* V8 Baby-X4 Quadruple Core -- rated for 30-70W, recommended 45-60W :: Start @ 30w and work up
* V8 Baby-T8 Octuple Core -- rated for 50-110W, recommended 60-80W :: Start @ 50w and work up
The .2ohm
* V8 Baby-T6 Sextuple Core -- rated 40-130W, recommended 70-90W :: Start @ 40w and work up
The coil that was preinstalled in my kit was the .4 ohm coil.you wouldn't happen to preinstalled