switching coils

[Jinx'd]

Innokin Cool Fire IV TC100W iSub V
iSub SS316L BVC 0.5ohm Vape Coil (Pre-installed) .I am using this coil

I have these coils.
iSub KAL BVC 0.5ohm Vape Coil
iSub 2 ohm 10-16w

what I want to know. what should I expect when switching to these ?

 

[Countrypami]

Innokin Cool Fire IV TC100W iSub V
iSub SS316L BVC 0.5ohm Vape Coil (Pre-installed) .I am using this coil

I have these coils.
iSub KAL BVC 0.5ohm Vape Coil
iSub 2 ohm 10-16w

what I want to know. what should I expect when switching to these ?

The kanthal will fire much quicker, flavor will be a little lighter.
The 2.0 will be a tighter draw, less vapor.

 

[Jinx'd]

The kanthal will fire much quicker, flavor will be a little lighter.

The 2.0 will be a tighter draw, less vapor.

thanx

I don't care about quick. what I am using now is just fine. I DON'T want to loose flavor. but, a few of the flavors I have, samples, are some STRONG chit ! bad, but STRONG. I will save this coil for when I have my flavors sorted out.

2.0 = ok, but how will that effect flavor.

 

[Countrypami]

thanx

I don't care about quick. what I am using now is just fine. I DON'T want to loose flavor. but, a few of the flavors I have, samples, are some STRONG chit ! bad, but STRONG. I will save this coil for when I have my flavors sorted out.

2.0 = ok, but how will that effect flavor.

Don't know, I haven't used the 2.0.

 

[Jinx'd]

I tried out the 2 ohm yesterday. while it does give a lighter hit, at times o found it good. also depends on the juice.
I think I will use them for work, did fine there. I would like to try a 1 ohm, if they ever have em.