hey all, help would be GREATLY appereciated for this situation.
So I bought a hannya postless rda right? Well I strip the grub screw on the positive post. Well, it's all the deep in there now. An EZ extractor won't fit in there. The hole is a few mm wide and a few cm deep. I know this isn't anyone's fault but mine, but I mean I was barely twisting and it happened the first time I tried building on it. So right now, I'm just running a .27 ohm 28 guage twisted single coil at 48 watts. I really want to run duals. I went into my local vape shop and they said to contact seller, after not finding a website or anything under the name of blitz enterprises, I contacted my seller (vapordna) in hopes they'll give some info on how to fix it. Now, I'm asking you guys with knowledge on the situation.
Thanks.
So I bought a hannya postless rda right? Well I strip the grub screw on the positive post. Well, it's all the deep in there now. An EZ extractor won't fit in there. The hole is a few mm wide and a few cm deep. I know this isn't anyone's fault but mine, but I mean I was barely twisting and it happened the first time I tried building on it. So right now, I'm just running a .27 ohm 28 guage twisted single coil at 48 watts. I really want to run duals. I went into my local vape shop and they said to contact seller, after not finding a website or anything under the name of blitz enterprises, I contacted my seller (vapordna) in hopes they'll give some info on how to fix it. Now, I'm asking you guys with knowledge on the situation.
Thanks.