This was sent directly from 3CVape for review Description provided by 3CVAPE: "Designed by squirmingcoils and 3cvape. Inspired by team members from @coilconspiracy. This Conspiracy RDA is an silver plated low profile 24mmRDA. This two post design is super easy to build on with spacious 3×1.5mm post holes. Adjustable airflow for single or dual coil builds. With the rare pure silver plated deck, we would like to call it a build machine." Arrived in a small plastic container. Right side of the label shows the Conspiracy logo @squimingcoils @3cvape Team @coilconspiracy Left side reads: Designed by squirmingcoils and 3cvape and inspired by team members from @coilconspiracy. The conspiracy RDA is a silver plated low profile 24mm This two post design is super easy to build on with spacious 3 x 1.5mm post holes. Adjustable airflow for single or dual coil builds. With the rare pure silver plated deck, we would like to call it a build machine. Top cap just shows the 3cvape logo Instructions is a small simple page that plainly tells you how to assemble this RDA. There are 4 bags of parts inside. 1. Screws, O-rings, and a gold plated 510 pin 2. Deck 3. Top cap and barrel 4. Ultem 810 drip tip, PEEK insulator, insulator ring, O-rings, screws, gold plated 510 squonk pin, and the positive post Plenty of spare parts. Provides the opportunity for standard RDA or squonk option. Both hex and slot screws. Close up of the spare parts Drip Tip: 810 Ultem 12.32mm tall 17mm OD and says "3CVAPE" on one side. 12.62mm OD where it pushes into the top cap. 8mm ID at top and reduces to 6mm ID. Will stand 8mm above the top cap.