Ohms jumping up and down

[surf472]

Well I have a dna 30 so it's considering a alright chip I guess, and it reads my ohms level in the screen, but in my ohms reader section thingy yesterday it was reading .5 ohms on the dot for a whole day, then I woke up today at .4 ohms now its reading .3 ohms... I can't go lower then .3 or it wont fire so yeah what's going on?

 

[MrScaryZ]

Well I have a dna 30 so it's considering a alright chip I guess, and it reads my ohms level in the screen, but in my ohms reader section thingy yesterday it was reading .5 ohms on the dot for a whole day, then I woke up today at .4 ohms now its reading .3 ohms... I can't go lower then .3 or it wont fire so yeah what's going on?

What Atty you have on it?? tighten all the screws if it is a RDA check your bottom pin clean your contacts then try again

 

[surf472]

What Atty you have on it?? tighten all the screws if it is a RDA check your bottom pin clean your contacts then try again

Well I'm using a mutation v4, the screws are tight as possible and I adjusted the pin a few times, if its too tight in there it will say check atomizer because of minimal to no contact being made.

 

[surf472]

My main issue is I know its not .3 ohms but since its reading it at .3 its dropping the voltage to 3... which I think may increase the time it takes to heat up and less vapor?

 

[MrScaryZ]

My main issue is I know its not .3 ohms but since its reading it at .3 its dropping the voltage to 3... which I think may increase the time it takes to heat up and less vapor?

hmmm yes that is possible.. are you using Kanthal?

 

[surf472]

24 awg kanthal