Become a Patron!

My mech mods

Weirdvapenj

Member For 4 Years
So I own a three and looking to get couple more but before I buy I must ask. I have some Sony vtc5 some Samsung 25 r and ohm wreckers but I'm not getting that freight train hit? Is it cause I'm used to regulated device. My mech only get used on special occasions. I cleaned them adjust them and made sure all batteries are fully charged. What can it be? No way I have that much voltage drop on all three mods with all the batteries.


Sent from my iPhone using Tapatalk
 

nightshard

It's VG/PG not PG/VG
VU Donator
Gold Contributor
Member For 4 Years
Before blaming it on voltage drop, what wattage are you used to on your regulated, which resistences are you building on your mechs and are they single, serial or parallel?
 

Weirdvapenj

Member For 4 Years
On regulated I Vape between 45 watts and 80 at the very highest. On mech I used a 24 g wire 8 wraps on 3mm drill bit getting .38 coil and the mechs are single 18650 mods


Sent from my iPhone using Tapatalk
 

martnargh

Silver Contributor
Member For 4 Years
Member For 3 Years
knock 2 or 3 wraps off that build should hit harder.

Sent from my SM-N920T using Tapatalk
 

nightshard

It's VG/PG not PG/VG
VU Donator
Gold Contributor
Member For 4 Years
0.38 ohm gives you from 45W to 25W +- try to aim to around 0.22
And besides building such a big mass coil and using it at low wattages is not optimal.
 
Last edited:

r055co

VU Donator
Platinum Contributor
Member For 4 Years
Also use smaller gauge SS wire, SS much more responsive than Kanthal. On a single 18650 I build around 0.2

Sent from my Nexus 6 using Tapatalk
 

VU Sponsors

Top