Kanger mini RBA pre-built coil question

[bri66799]

I purchased the pre Made coils 20 pack 0.5 ohm I have a question am I supposed to dry fire and squeeze together the coil with tweezers before wicking or is there supposed to be space between the coils

Sent from my SM-N915P using Tapatalk

 

[AmandaD]

Are these for the subtank rba? If so yes, just give them a pulse or two. Probably no need to squeeze them, but pulse to oxidise a little.

 

[bri66799]

Yes the sub tank mini

Sent from my SM-N915P using Tapatalk

 

[bri66799]

Also how tight is the Cotton supposed to be should you be able to move it easily or should it be pretty firm

Sent from my SM-N915P using Tapatalk

 

[bri66799]

Also how tight is the Cotton supposed to be should you be able to move it easily or should it be pretty firm

Sent from my SM-N915P using Tapatalk

Sent from my SM-N915P using Tapatalk

 

[Lefty]

These were wrapped to be spaced coils, best to use them that way. Dry burn to burn off any possible residue from being made. The cotton should have a little resistance when you pull it through the coil. Pull it back and forth a little once in to be sure the cotton isn't packed too tightly under the coil. If you get too much crackling and spitting when vaping use a little more cotton the next time. Dry hits use less. You'll get a feel for it.

 

[kwtony]

Im just going to leave this here

http://vapingunderground.com/threads/first-look-new-vertical-occ-coil-rebuild.113865/#post-602931