Istick50 ...problem

[RodThaVapenRat]

Well it keeps jumping from .3 to .4 and it is drastically changing the heat of the vape.I'm using a Herakles subtank with a .2 coil ....it never read as a .2 tho.... Wtf is going on

"War,war never changes

Only The Means of Destruction"

 

[Maverik_X]

Well it keeps jumping from .3 to .4 and it is drastically changing the heat of the vape.I'm using a Herakles subtank with a .2 coil ....it never read as a .2 tho.... Wtf is going on

"War,war never changes

Only The Means of Destruction"

Check your 510 pin also make sure that coil is tight in the air flow control base. I believe those coils are .25ohms so the mod should show .3 ohm I'm not sure if the istick is supposed to fire down that low.

 

[RodThaVapenRat]

Check your 510 pin also make sure that coil is tight in the air flow control base. I believe those coils are .25ohms so the mod should show .3 ohm I'm not sure if the istick is supposed to fire down that low.

I'm about to check the 510 and the istick50 can fire down to .2

"War,war never changes

Only The Means of Destruction"

 

[Maverik_X]

I think it's the 510 pin or the coil isn't snug on the tank base.

 

[RodThaVapenRat]

Oh shit ran in to 510 problems with the istick30

"War,war never changes

Only The Means of Destruction"

 

[RodThaVapenRat]

Well cleaned the 510 and cranked down hard on the coil.... It's not jumping now but I have never had to tighten down a coil like that......lets see how long it works ..and thanks @Maverik_X

"War,war never changes

Only The Means of Destruction"

 

[RodThaVapenRat]

Well it was good till this morning......... It stays at .3 but when it gets warm it starts bouncing again

"War,war never changes

Only The Means of Destruction"

 

[UncleRJ]

There is the possibility that the connections to the coil in the head are loose.

I have had the same thing happen to me with my RTA builds. If one of the legs is a bit loose, the reading will start jumping around as the coil heats.

BTW, IMHO, cranking down on any connection more than finger tight will end up in stripped threads sometime in the future.

 

[RodThaVapenRat]

It's doing fine now redone everything...lets see this go round

"War,war never changes

Only The Means of Destruction"