How to mount tact switch and small potentiometer

Discussion in 'New Builders Corner' started by Spamspamspamidntlikespam, Feb 5, 2019.

  1. Spamspamspamidntlikespam

    Spamspamspamidntlikespam New Member

    Blog Posts:
    0
    Joined:
    Nov 9, 2018
    Messages:
    1
    I'm building a new pwm box and I'm drawing a blank on how to mount a tactile switch and the small potentiometer I got from motley mods. I really should've just got the presoldered version but I didn't really want a low voltage cutoff. I'm gonna try using a scrap tact switch to save room, any ideas on a relatively easy way to make a mount would be greatly appreciated. The pot is basically the same as the switch, so whatever works for one should work for the other. Thanks.
     
  2. PoppaVic

    PoppaVic Gold Contributor Member For 4 Years

    Blog Posts:
    0
    Joined:
    Sep 5, 2014
    Messages:
    1,780

Share This Page

Close This Message