HELP! rDNA 30 watts won't change

[Kfb]

Watts stuck at 7 Any help would be greatly helpful

 

[Kfb]

Stuck at 7 watts

 

[rdsok]

Make certain you didn't lock the device or the output settings... see http://www.evolvapor.com/datasheet/dna30.pdf

 

[Whiskey]

Sounds like it could also be the board, defective?
I also know that depending on what cart/tank 2.0 olm atty I have on my Istick it won't go beyond 14.5

 

[UncleRJ]

Long shot but give it a try.

Remove the battery and let the device set a bit so any excess current can bleed out of the capacitors.

Then try it again.

 

[Whiskey]

Merging this thread as a double to here http://vapingunderground.com/threads/help-rdna-30-watts-wont-change.40127/#post-223466

 

[Fictitious Character]

If it is not locked and pulling the batts do not reset it then a service call sounds in order.

 

[Zamazam]

I had that happen on one of my DNA30D devices, it was a cold solder joint on the positive pin of the 510 connector, thus increasing the Ohm's reading erroneously.

 

[matt815]

I have the same problem, mine won't lower the wattage.

 

[dre]

Could be just a bad switch you can try the inboard switches or even short the two leads on the switch. If it changes watts its the switch.

 

[matt815]

Onboard switch doesn't work.