Ok, so now this seems awesome.
But is it worth paying $84.95 for one?
Steps of Operation:
http://www.shop.usaohmmeters.com/3D-Fire-Meter_c30.htm
But is it worth paying $84.95 for one?
This is a much needed device for those that are tired of building on an ohm meter, switch it over to a device to fire and adjust the coil(s), returning back to ohm meter to check resistance, going back to device to fire and more adjusting, back to ohm meter to check resistance...and so forth...you get the picture if your a builder.
Steps of Operation:
- Screw on RDA
- Build Coil
- Switch over to Fire Mode and pulse button to warm coils
- Adjust coils
- Switch over to Ohm Meter Mode and wait for resistance to normalize...this is the resistance you normally see
- If all is proper to your liking, add wicking material, tuck your wick, and drip a few drops to get wicking material wet
- Switch back to Fire Mode to test the firing
- Remove RDA (use caution when removing, may be hot)
http://www.shop.usaohmmeters.com/3D-Fire-Meter_c30.htm