Eleaf iJust 3 with an RDA?

Discussion in 'New Builders Corner' started by BeginnerOfVaping, Aug 7, 2018.

  1. BeginnerOfVaping

    BeginnerOfVaping New Member

    Blog Posts:
    0
    Joined:
    Aug 7, 2018
    Messages:
    2
    Hello,

    I've seen quite a lot iJust S and iJust 2 RDA builds, so I wanted to ask this...
    The question that made me curious is why those two but not the iJust 3?
    The iJust 3 can output up to 80W, while the iJust S can output only 50W.
    Could it be, that no one has thought of an RDA build with the iJust 3 and
    It is still pretty new to the market?
    Otherwise everything is ok?

    Thank you.
     
  2. gbalkam

    gbalkam Gold Contributor Member For 2 Years ECF Refugee Reddit Exile

    Blog Posts:
    0
    Joined:
    Jun 10, 2016
    Messages:
    1,596
    looks like any RDA would work, just make sure your build is above 0.10 and below 0.30. Not hard to do, just use steamengine.org coil calculator... just to be safe..given the battery.. I would aim for around 0.20 ohm. (20A draw)
    http://www.steam-engine.org/coil.html
     
  3. BeginnerOfVaping

    BeginnerOfVaping New Member

    Blog Posts:
    0
    Joined:
    Aug 7, 2018
    Messages:
    2
    Thanks for the reply!
    Glad that it would work! But why
    Between 0.10 and 0.30ohms? The battery
    Can support from 0.10 to 3.0ohms and
    output up to 80w around 26A (Atleast on paper).
    Since it is a "Smart hit" battery, it would
    Apply 80W at full charge and drop until it
    reaches it's discharge limit.
     

Share This Page

Close This Message