Dual Clapton parallel coils question

Discussion in 'Ask An Expert' started by Oxygen211, Aug 22, 2018.

  1. Oxygen211

    Oxygen211 New Member

    Blog Posts:
    0
    Joined:
    Aug 22, 2018
    Messages:
    3
    Ill try to make this as short as possible. I bought a prebuilt coil pack from Coil master (8-1 skynet). Hooked up the clapton parallel coils to my goon 1.5. After pinching and raking the coils they read .102 ohms on my regulated mod when the package says .3 ohms +- .05. I know running dual coils its half the marked ohms but the math doesn't add up even on the lower side of the resistence. Is this normal for these type of coils or should i be worried? I switched to vaping from cancer sticks only 6 months ago so I'm still fairly new at this.
     
  2. Kitsune

    Kitsune New Member

    Blog Posts:
    0
    Joined:
    Jul 6, 2018
    Messages:
    83
    Are those Ni80 coils?

    If yes, let them glow after installing them, Ni80 will show lower ohms until it glowed the first time :)
    Your phenomenon sounds like typical Ni80 pre-glow behavior.

    You do know how to properly install new coils, don't you? As in installing them, adjusting them, letting them glow and removing hotspots before wicking.
    Just asking since you've written you're fairly new.
     

Share This Page

Close This Message