Could use some help...

[Crackjar]

So for some reason my Ohms are dropping after my build, this has happened twice now, using 26G Kanthal A1, dual coil build shows to be .54 on my Ohm Meter, then after I wick and apply the juice, Ohms drop to about .5, perfect actually, BUT once I attach the Atty to my VaporFlask and select New Coil, it measures as .48, then as I apply power the Ohms drop from .48 to .38 rapidly. All connections are tight and secure, but I can't figure out what's really happening, why are the Ohms dropping so rapidly?

 

[vaperature]

What atty and wick are you using?

 

[Crackjar]

Mutation X V3 w Koga Japanese Cotton

 

[vaperature]

Once it drops to .38 does it stay there or does it keep fluctuating?

 

[Crackjar]

Once it hits .38 it holds steady then drops to .37, then back to .38, once I release the power it puts the Ohms back at .48

 

[vaperature]

 

[Crackjar]

Classic! But yeah, definitely a bit confused, just tried rebuilding altogether, steady at .54 Ohms, Vaping/Tastes Great.

 

[Shawn.freeman50]

Loose contact some were or check to see If there is a piece of kanthal in the post holes

 

[Crackjar]

I checked all the post-holes, made sure everything was clean, looking good and no debris anywhere. Still not sure but it's working fine now after another build