sorry for the late response didnt expect such a quick reply, thanks for help and input seriously, and noice coil pics and nice high walls on that deck,
since posting this, i was leaning towards mech mods actually, and found an, avid lyfe medieval gyre slayer, and use the asgard 25mm rda and taking the drip tip from the cloudy collaborations strife 25mm rda all in matte black, thought that would look cool almost like a viking found this vape build on a battlefield, then i would be using the sony murata vtc5d 18650 2800mah 25a battery, was looking at running, annealed nickel wire ni200 24 gauge awg 0.16 ohms/ft @ room temp, looked up ohms law calculator and if the wire holds true and with these batteries, the output should put it around,
.16 ohms
23.125 amps
3.7 volts
85.5625 wattage
however going to .10 ohms will increase amps to 37 and wattage to 136.9 which will definitely put the battery into a dangerous situation to possibly vent/explode, how reliable is your average wire? does the resistance drop as it gets older, used, and tempetature outside changes, in anyones experience increasing the amps/wattage? thought about this just in case, before i heard anyones thoughts and with going to a 26 gauge ni200 .24 resistance would drop the amps to 15.4166667 and the wattage to 57.0416667 so even with the possible fluctuation of wire resistance if there even is such a thing with extended and prolonged use i will still remain in the safe range of the batterys capabilities,
heard nickel is the fastest wire for heating up but titanium wire also heats up quickly and cools down quickly with double the resistance of nickel, of course i will need to test all of this on the decks for resistance with different wire coil builds attached, also, does stacking wires increase the resistance if i twisted and stacked 2 or 3 together? dragonskin looked cool and seems relatively easy to make and would definitely go with my build, lots of how to videos on wire coil builds on youtube, heard somewhere sub ohming is good for clouds so super sub ohming around .16 would be definitely as far as i would go but wasnt sure whether or not resistance fluctuation after continued use pushing the battery into potential dangerous output levels near .10 resistance or does resistance never change no matter the length of usage? but of course the wire coils need to be eventually changed, so thats why i think to ask this, want to go .16 but will probably go .24, or might just get both and keep monitoring the resistance for coils life, how long do you think i can use a dragonskin ni200 wire coil build for? backing off from chain vaping no less
thoughts on this new build? input on wire type and gauge? super sub ohming? also i dont plan to chain vape as heavily anymore which will be easier on the mod/battery and all that, want to maintain eating healthy and working out, any information would be greatly appreciated.
