Billet Box SxK 70 to DNA60 swap?

Discussion in 'Performance Modifications' started by Droopydroors, Jun 29, 2017.

  1. Droopydroors

    Droopydroors New Member

    Blog Posts:
    0
    Joined:
    Apr 6, 2017
    Messages:
    63
    Question on wiring the off board buttons. The SXK 70 has a 3 wire up and down component with 2 wires for the up and down and one for the ground. Looking at the DNA60 board specs it shows the up and down buttons both having a ground. Can I just run the single ground to one and leave the other open? Any help would be great. IMG_20170629_000023122.jpg Screenshot_20170629-000148.png
     
  2. crazydmnd

    crazydmnd Bronze Contributor Member For 2 Years

    Blog Posts:
    0
    Joined:
    Oct 4, 2014
    Messages:
    316
  3. dre

    dre Gold Contributor Member For 2 Years ECF Refugee

    Blog Posts:
    0
    Joined:
    Sep 29, 2014
    Messages:
    4,826
    Wire one normally and the other just to the +[​IMG]

    Sent from my XT1585 using Tapatalk
     
  4. Droopydroors

    Droopydroors New Member

    Blog Posts:
    0
    Joined:
    Apr 6, 2017
    Messages:
    63
    IMG_20170701_221031041_BURST000_COVER_TOP.jpg
    I should have posted that it is finished thanks Dre. But yes I just checked the continuity between the 2 negatives.
     
  5. NitoCleto

    NitoCleto New Member

    Blog Posts:
    0
    Joined:
    Jul 31, 2017
    Messages:
    1
    Nice thanks I was just looking for this


    Sent from my iPhone using Tapatalk
     

Share This Page

Close This Message