Ok I have a silly question my brother in law has a segeli 150w tc and is wanting to play with different wires for tc. I know that if you device doesn't have a setting for titanium you basically use 100 degree offset on the temperature. Is ther a similar technique for stainless? I personally have a dna200 so I don't have thus problem, but my brother in law cannot afford to get one at the current moment.
Become a Patron!
Setting up a tc mod for ss
- Thread starter wolfmannxx
- Start date
What CV are you using for the DNA 200 I'm having a hard time getting the smok TF-STC2 to work right.
I just been using the 316l profile
Bucky205
Bronze Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
I've
I've run T1 on my Sig 150 TC, just playing around. I started with 150 degrees lower than Ni, then I just played with the temp until it wouldn't burn. It ended up being like 325 degrees. Didn't vape it for long, just wanted to try it, because of another article I read stating you could do it with half the temp of Ni200. Half didn't work, it was closer to 100-150 degrees less than Ni200.
I'll try thay
I just finished wrapping SS wires which give me 0.3 ohm (dual coils) on my Bambino. I finally set my Wismec Reuleaux DNA200 at 220F 51 watts. It's working great. I started off setting at almost 400F and that was way too high especially for the Bambino. Great flavor and lots of cloud, if I may say so.
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk