Yea that's how I wicked when I first got it. Since learned the rda style wicking protecting the air holes will let u all know how it goesLet us know how well it wicks, etc. That channel stuffing wicking is far from ideal. May not be necessary either.
i think if i can find a good way to plug the airflow holes i can top fill. just havent tried yet
0.2 ohms. Not as good as quads, bit better than zipper.Gorgeous!
yea it leaks when i fill it but its the only option. had a feeling it would before i even tried, but it doesnt let out a lot. i plug the airholes with my fingers as tight as possible, fill, put the cap on, let go, then immediately start vaping but still some juice does get out. not any significant amount of the tank though, just some loose juice i guess. coming from a v3 though with no extra parts it brought my orchid back to life big time, havent gone back to the kayfun v4 deck since i tried it
yea you can my juice is just too thick for that though. i found out last night i can fill with a lot less juice getting out and less mess. before removing my fingers flip it over, remove fingers then blow through the chamber with a paper towel and everything will get out with one breath. then no leaking at all
feel your pain, been there myself man
"Orchid X" as in eXtracted from the already available parts bin.
Except for the copper center pin, which made its entrance and exit with the bogus V5.
Don't feel bad.. admittedly I've tanked two. One drilled crooked came through at the very base of the chimney and the other was a glass tank v6 which didn't like the 1/8 bit.. it ended ROYALLY fucked lol
It's posted somewhere back on this thread.
Lol it was, rip a hole in the bottom of the deck where the rubber grommet seals it :/Yeah, that 1/8" bit can sometimes be "a bit too far."
