Become a Patron!

Innokin iSub B (Plex3D) tank dry hitting

Garemlin

Gold Contributor
Member For 4 Years
ECF Refugee
So the other day I decided to thoroughly clean one of my iSub B tanks. The newest iSub tank with the Plex3D coils. After priming a new coil and filling it I started to get dry hits after a few puffs. Thought maybe I got a bad coil. Which after using four of these since they came out with zero bad coils I wasn't that upset. So tried a new coil and got the same results.

So apparently during my cleaning I did something. I have looked it over and tried to figure out if maybe I lost an o-ring somewhere. But I can't see where that might have been. And I can't find a diagram online anywhere. I can't think of anything else that could have happened during cleaning that would cause a working tank to suddenly start dry hitting.

Anyone familiar with the iSub B that can offer any suggestions?


Tap'd from my iPhone XR
 

Garemlin

Gold Contributor
Member For 4 Years
ECF Refugee
Figured out the problem. The bubble glass has two different size lips. I had it on upside down putting the taller lip at the top not allowing the juice control to fully open.


Tap'd from my iPhone XR
 

VU Sponsors

Top