lordmage
The Sky has Fallen. the End is Here.
Staff member
Senior Moderator
VU Donator
Gold Contributor
ECF Refugee
Member For 5 Years
well i think i found the best for me method for the unity and the RDA...
in the rda i use 3x firebolt 2 top 1 bottom cut the bottom to the edge of the mesh trim top to barely touch the deck. perfect for days if not weeks squonking. i run it at 40 watts and i am happy with that.
in the rta i switched to the 316L
same amount of cotton 2x bottom trimmed flush with outer edge of the deck then angle slightly stuff it in and forget it. top is cut flush with the inner ring of the well edges matched to the same inner ring. tuck the longer fibers i am currently running it on my 250c at 450 F 40 watts and i am happy with that.
the one thing i make sure of is that the well is only half filled with cotton across the bottom edge once stuffed. the top is fluffy as can be.
Air flows wide open on both...
still experimenting with trim and placement in the unity the RDA could go higher but i am a chain vaper so it stays nice and warm.
in the rda i use 3x firebolt 2 top 1 bottom cut the bottom to the edge of the mesh trim top to barely touch the deck. perfect for days if not weeks squonking. i run it at 40 watts and i am happy with that.
in the rta i switched to the 316L
same amount of cotton 2x bottom trimmed flush with outer edge of the deck then angle slightly stuff it in and forget it. top is cut flush with the inner ring of the well edges matched to the same inner ring. tuck the longer fibers i am currently running it on my 250c at 450 F 40 watts and i am happy with that.
the one thing i make sure of is that the well is only half filled with cotton across the bottom edge once stuffed. the top is fluffy as can be.
Air flows wide open on both...
still experimenting with trim and placement in the unity the RDA could go higher but i am a chain vaper so it stays nice and warm.