I was looking for a squonk mod for my Profile RDA and picked up the iJoy kit from DirectVapor.com a couple of months ago for $25. A few weeks ago the up/down button was stuck on down and wouldn't go higher than 5w. Disassemble and cleaning worked but then it began to auto fire. I contacted DirectVapor who told me it was a few days out of warranty and contact iJoy. I took it apart again and cleaned it as best I could with alcohol and let it dry for a day. That worked but before putting it all back together I stuffed as much paper towel pieces as I could fit, especially around the fire button and the top part of the juice feed line. I figure that it will still leak but the paper towel pieces would absorb it rather than have it travel throughout the circuit board. I'll probably have to replace the paper towel bits every so often but I really like the mod and hope this works for a while. Be careful when cleaning the circuit board, after removing the two screws that hold it in place it is very easy to break off the two small wires to the usb socket. I had to re-solder mine back on. Also, Hack my mod by Mike Vapes has a good video on replacing the bottom feed rod with a silicone bottle and tube. I think that would stop the leak in the first place. It seems that by the rod moving back and forth when squonking allows the juice to leak where it pivots. Keeping my fingers crossed.