Sorry if this is in the wrong place, first time here.. =)
Recently upgraded from a simple Aspire CF sub ohm and Nautilus tank to a Smoke Alien 220w and Baby Beast kit. From what I can tell it is performing well, vapor density wise, compared to the Aspire stick that is. However much of the screen data doesn't appear accurate.
Testing batteries with a multimeter at full charge shows both at around 4.2v.. The Alien always reads at 3v or less. Also I switched to the quad coil atomizer that was included in the kit, I understand it's supposed to be .15ohm, but display reads .405 ohm..I can't recall what the ohm reading was for the pre installed coil. The Amp reading bounces from as low as 7 to as high as 28 seemingly at random.
Am I missing some setup steps or anything? I followed the manual and Googled a bit, but couldn't come up with much related to my specific issue. Seller has been slow to respond.
As a side note, even with full charge and ramp mode set to high, it takes over 2 full seconds of firing before it starts producing decent vapor and coils making noise. Watt setting seems to have little effect on this delay. Is this normal? My Aspire stick is always making noise, coils simmering ready to go in literally a split second.
Sorry for the wall of text, very much appreciate any help or insight. Thanks!
Recently upgraded from a simple Aspire CF sub ohm and Nautilus tank to a Smoke Alien 220w and Baby Beast kit. From what I can tell it is performing well, vapor density wise, compared to the Aspire stick that is. However much of the screen data doesn't appear accurate.
Testing batteries with a multimeter at full charge shows both at around 4.2v.. The Alien always reads at 3v or less. Also I switched to the quad coil atomizer that was included in the kit, I understand it's supposed to be .15ohm, but display reads .405 ohm..I can't recall what the ohm reading was for the pre installed coil. The Amp reading bounces from as low as 7 to as high as 28 seemingly at random.
Am I missing some setup steps or anything? I followed the manual and Googled a bit, but couldn't come up with much related to my specific issue. Seller has been slow to respond.
As a side note, even with full charge and ramp mode set to high, it takes over 2 full seconds of firing before it starts producing decent vapor and coils making noise. Watt setting seems to have little effect on this delay. Is this normal? My Aspire stick is always making noise, coils simmering ready to go in literally a split second.
Sorry for the wall of text, very much appreciate any help or insight. Thanks!